Hi Frank and others,I'm not sure how they change the layout.  It might have 
been in the way the circuits boards.  Kenwood might have changed it so they 
can sell more Microphones.  73.  Gary KB2YAA

-----Original Message----- 
From: Frank Ventura
Sent: Friday, October 23, 2015 9:49 PM
To: [log in to unmask]
Subject: Re: Identifying a Kenwood dual band radio

Yes thanks, I plugged in the mike from my TMV71a and it did just that. It w=
orked but the keypad didn't work. What are the differences between those tw=
o mikes you mentioned?
Frank

-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]] =
On Behalf Of [log in to unmask]
Sent: Friday, October 23, 2015 2:25 PM
To: [log in to unmask]
Subject: Re: Identifying a Kenwood dual band radio

Hi,
I must differ, the mike for the TMV71A will work on the TM-V7A, butPF butto=
ns will not work.  The correct mikes for the TM-V7A are the MC53DM andd the=
MC58DM only.  73. Gary KB2YAA

-----Original Message-----
From: Don Breda
Sent: Friday, October 23, 2015 6:35 AM
To: [log in to unmask]
Subject: Re: Identifying a Kenwood dual band radio

The mic for that radio is the same as the one for the tm-v71a which I belie=
ve you have.

Don



On 22-Oct-15 6:22 PM, Frank Ventura wrote:
> Hi all, I need a little help identifying a dual band (2m/440) radio.=20
> It loo=3D ks similar to a Kenwood TMG707 but in the bottom left there=20
> are two volume/=3D squelch knobs just like a new TMV71a. On the left=20
> there are three button Ca=3D ll, VFO and MR and the tuning knowb is=20
> beneath that. To the right of the tu=3D ning know there are four round=20
> buttons. To the right of those buttons there=3D
>   are the two volume/squelch knobs and a small button between them.=20
> Above on=3D
>   the right side is the power button, PM and menus buttons. The radio=20
> works =3D fine but I would like to nail down an exaxt model so that I=20
> can download a =3D manual.
>
> Thanks
>
> Frank