The worst thing that will happen, is the magic smoke will fall out. And you can't put it back in.
Sent from my iPhone this time
> On Nov 22, 2015, at 3:40 PM, Tom Behler <[log in to unmask]> wrote:
>
> Howard:
>
> That's what I thought, which I was a bit surprised at the 16 amp output for
> the PS53. If I'm interpreting them correctly, the TS590 spects say that on
> high power, the rig uses less than 20 amps, but I'm not sure exactly what
> that means.
>
> You are encouraging me to just give the PS53 a try here, to see what
> happens.
>
> Tom Behler: KB8TYJ
>
>
> -----Original Message-----
> From: For blind ham radio operators [mailto:[log in to unmask]]
> On Behalf Of Howard, W A 9 Y B W
> Sent: Sunday, November 22, 2015 5:08 PM
> To: [log in to unmask]
> Subject: Re: Question On Kenwood PS53 Power Supply
>
> Tom,
>
> I am using said Kenwood power supply with my TS-590. It was originally
> purchased to go with my TS-570.
>
> Both radios are 100 watt radios.
>
> Howard #3
> W A 9 Y B W
>
>
> ----- Original Message -----
> From: "Tom Behler" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Sunday, November 22, 2015 3:04 PM
> Subject: Question On Kenwood PS53 Power Supply
>
>
>> Hello, everyone.
>>
>>
>>
>> I think I'm becoming more and more convinced that something might be going
>> wrong with the trusty Astron RS35 linear power supply that I have been
>> using
>> here in the home shack for the past 18 years.
>>
>>
>>
>> Today, I had my XYL check the meters on the supply when keying up in RTTY
>> mode with 100 watts with my TS590, and the meters on the supply read 14
>> volts, with only a draw of 11 amps. I did this on a frequency for which
>> my
>> DXCC antenna is resonant on 40 meters. My SWR was 1.0 to 1, both
>> according
>> to the TW1 and the meter on the TS590. I then checked my output power
>> reading. According to the TW1, it was 57 watts, and according to the
>> TS590
>> meter, the output power was 75 watts.
>>
>>
>>
>> After our lenghthy discussions several weeks ago, when I noticed output
>> power problems with my TMV71A, I tried my best to clean all DC power
>> connections.
>>
>>
>>
>>
>>
>> My next step will be to try another power supply, just to see if that
>> makes
>> a difference, which brings up a question.
>>
>>
>>
>> Does anyone on list have a Kenwood PS53 power supply? I obtained this
>> supply from an estate sale several years ago, and I think it is meant to
>> be
>> used with the Kenwood TS570, which I also obtained at that time.
>>
>>
>>
>> I had my XYL check the power draw ratings on the supply, and she told me
>> it
>> says 16 amps. This seems a bit low to me, and may not be adequate for the
>> TS590 on the full 100 watts.
>>
>>
>>
>> If anyone has accurate power draw ratings, or an accessible manual for the
>> PS53 supply, I'd appreciate the additional info.
>>
>>
>>
>> I'm hoping to do some further experimenting with all of this during the
>> upcoming Thanksgiving break.
>>
>>
>>
>> Tom Behler: KB8TYJ
>
>
> ---
> This email is free from viruses and malware because avast! Antivirus
> protection is active.
> http://www.avast.com
|