Thank you Gale. Although I looked in my manual, either I overlooked the
information you have provided or I was looking at the wrong place!
This is exactly what I need, thank you VERY much.
Kent Plemmons, KK4FFF
-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Gale Conard
Sent: Tuesday, May 26, 2015 6:08 PM
To: [log in to unmask]
Subject: Re: TM-V71A setting offset freq
Kent:
I copied this from the operators' manual for the TMV-71A. I hope it helps.
STORING ODD-SPLIT REPEATER FREQUENCIES
Some repeaters use a receive and transmit frequency pair with a non-standard
offset. To access those repeaters, store two separate frequencies in a
memory channel. You can then operate on those repeaters without changing the
offset frequency you stored in the menu.
1 Set up a simplex channel by following steps 1 to 6 of "STORING SIMPLEX AND
STANDARD REPEATER FREQUENCIES", above.
2 Press [VFO] to enter VFO mode.
3 Rotate the Tuning control to select your desired transmit frequency.
. Additionally, you can press the microphone [UP]/[DWN] keys to select a
frequency.
4 Set up any additional data desired for the transmit frequency.
. Tone ON/OFF, Tone frequency, CTCSS ON/OFF, CTCSS frequency, DCS ON/OFF,
DCS code, etc.
5 Press [F].
. A memory channel number appears.
6 Rotate the Tuning control to select your desired channel number.
. Additionally, you can press the microphone [UP]/[DWN] keys to select a
channel.
7 Press [PTT], [MR] to store the data in the selected Memory channel.
73,
Gale
[log in to unmask]
----- Original Message -----
From: "Kent Plemmons" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Tuesday, May 26, 2015 10:49 AM
Subject: TM-V71A setting offset freq
Hi List,
Can anyone tell me how to set an offset frequency of 0.990MHz on my TM-V71A?
My receive freq is 146.775 and my transmit freq needs to be 147.765.
When I go to menu #400 to select an offset value, it appears that all of the
available offset values are in multiples of 0.05MHz.
There must be another way to do this using the radio but I haven't run
across the solution yet.
Thanks
Kent Plemmons
Clyde NC KK4FFF
|