Correction, I said Velcro in my last email, I meant magnets, when 
closing the case.  Jim WA6EKS

----- Original Message -----
From: Jim Gammon <[log in to unmask]
To: [log in to unmask]
Date sent: Mon, 20 Apr 2015 10:11:54 -0700
Subject: Using the Executive Products case

Tom, I usually just flap the top or front of the case around
behind the Stream thus leaving the front open to the air.  The
charger plug fits fine then but unless you get really wild with
your drinks, it should be fine left that way.  One thing I have
been somewhat concerned about is that if you flip the top around
from the back to cover the front and the charger is plugged in,
then the part that velcros to the case to close it can hit the
charger plug and over time, if this happens, that might cause
damage to the female plug on the Stream.  Jim WA6EKS

----- Original Message -----
From: Tom Behler <[log in to unmask]
To: [log in to unmask]
Date sent: Mon, 20 Apr 2015 07:04:52 -0400
Subject: Re: Resolution of Humanware problem with the VR Stream

Will work on it, Dave.

The case does fit very tightly, so perhaps a little massaging
will do the
trick.

The other thing I don't like about the case is that you can't
close it and
charge the unit at the same time, because there is no hole in the
top cover
to accommodate the plug to the charger.

Oh well, life isn't perfect, I guess.  (smile)

Tom Behler: KB8TYJ


-----Original Message-----
From: For blind ham radio operators
[mailto:[log in to unmask]]
On Behalf Of Dave Allen
Sent: Sunday, April 19, 2015 10:40 PM
To: [log in to unmask]
Subject: Re: Resolution of Humanware problem with the VR Stream

Hi Tom!

I'm able to do it.  I didn't modify the hole.  Perhaps masaage it
a little,
and it will play nice.

73,
Dave