Hello Colin, thanks for the info.  I'll give it a try.

Alan - N7MIT


Alan R. Downing
Phoenix, AZ

-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Colin McDonald
Sent: Wednesday, May 13, 2015 2:52 PM
To: [log in to unmask]
Subject: Re: I-Phone question

Hey Alan:
a two finger double tap will hang up the call...it will also answer incoming

calls.
When you are hanging up, angle the phone away from the vertical so that the 
speaker is activated and perform a two finger double tap to hang up
You are likely stuck in the keypad screen while leaving your voice mail.  At

the far right side of the screen, if you keep flicking right after the 0 
button  there is a "hide call" button...single finger double tap this button

to bring up your call screen where you will find the end and hold buttons 
etc.

73
Colin, V A6BKX
-----Original Message----- 
From: Alan R. Downing
Sent: Wednesday, May 13, 2015 3:41 PM
To: [log in to unmask]
Subject: I-Phone question

Good afternoon all.



Occasionally while leaving a voice mail message, I am unable to end the call
when my message is finished.  Regardless of where I move my finger around on
the screen, no where do I find an "end call" button.  Being unable to
terminate the call, the voice mail system just keeps on recording until the
limit of the system is reached.  Is there any fail safe way of terminating a
call whether the "end call" button is found or not?  It is sort of
embarrassing when the party retrieves my message and it drags on for several
minutes with no audio.



Any suggestions would be appreciated.



Alan - N7MIT





Alan R. Downing

Phoenix, AZ