Thanks, Matt.
I'll check into this.
Tom Behler: KB8TYJ
-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Matthew Chao
Sent: Sunday, April 26, 2015 8:47 AM
To: [log in to unmask]
Subject: Re: RG8X VS RG8U
My station has all LMR240. Easy to work with, and not too heavy.--Matt,
N1IBB.
At 08:42 PM 4/25/2015 -0700, you wrote:
>For whatever it might be worth, I will not use any of the RG series of
>coax, with the one exception of RG-142 which is a very good cable to
>use in the shack for low power jumpers. For example, as a jumper
>between the transceiver and amplifier. Otherwise, I use only cable
>from Times Micro, or hard line from Andrew. For low power jumpers,
>LMR240UF works very well, and for high power jumpers I typically use
>LMR400UF or LMR600UF. For my money, Time Microwave makes better cable
>than Beldin. You can buy any cable at all from Tessco.com.
>
>Alan - N7MIT
>
>
>
>
>Alan R. Downing
>Phoenix, AZ
>
>-----Original Message-----
>From: For blind ham radio operators
>[mailto:[log in to unmask]]
>On Behalf Of Tom Behler
>Sent: Saturday, April 25, 2015 8:21 PM
>To: [log in to unmask]
>Subject: Re: RG8X VS RG8U
>
>Thanks, Howard.
>
>Tom Behler: KB8TYJ
>
>
>-----Original Message-----
>From: For blind ham radio operators
>[mailto:[log in to unmask]]
>On Behalf Of Howard, W A 9 Y B W
>Sent: Saturday, April 25, 2015 11:07 PM
>To: [log in to unmask]
>Subject: Re: RG8X VS RG8U
>
>Tom,
>
>The RG8X is rated at 1500 watts and is a smaller diameter about that of
>RG59. RG8U is much larger and heavier and the losses below 30 MHz are
>probably similar. I would go with the smaller, lighter RG8x.
>
>My thoughts
>
>Howard #3
>
>----- Original Message -----
>From: "Tom Behler" <[log in to unmask]>
>To: <[log in to unmask]>
>Sent: Saturday, April 25, 2015 9:23 PM
>Subject: RG8X VS RG8U
>
>
> > Hello, everyone.
> >
> >
> >
> > This afternoon, A friend and I took down my Alpha Delta DXCC antenna
> > from the camp site we used last year, and I'm getting ready to put
> > the antenna up at a different camp site that we will be using this
season.
> >
> >
> >
> > I have noticed that the 75 feet of RG8X coax I have used as a
> > feedline for probably the past 1 or two years seems flaky, in that I
> > get a short across both of the coax connectors when I check for
> > continuity. I took off one of the connectors that I felt was
> > questionable, and installed a new one, just to have the same problem
> > recur. I am beginning to think that my best option might be simply
> > to replace the old coax with something new, rather than risk getting
> > the antenna up in the air at the new camp site, only to have a bad
> > feed line.
> >
> >
> >
> > I have 100 feet of RG8U here, and am considering using part or all
> > of that coax run, depending upon how much I will need, rather than
> > buying completely new RG8X. I will have to put connectors on the
> > RG8U if I go this route, but that shouldn't be too big of a deal.
> >
> >
> >
> > My question is this: Can someone tell me how RG8X and RG8U compare,
> > for a simple HF installation? Initially, I was going to put the
> > RG8U in my go kit, and use it for emergency VHF/UHF communications,
> > but if it would be ok for my HF RV installation, I may just go that
> > route for now.
> >
> >
> >
> > Any wisdom on the topic would be appreciated.
> >
> >
> >
> > Tom Behler: KB8TYJ
> >
> >
> >
> >
> >
> >
>
>
>---
>This email is free from viruses and malware because avast! Antivirus
>protection is active.
>http://www.avast.com
|