Howard:
Just checking this briefly, I have noticed that the = 20 symbols appear in
this message, which makes it difficult to read.
Could you re-send?
Tom Behler: KB8TYJ
-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Howard Kaufman
Sent: Thursday, April 17, 2014 8:45 AM
To: [log in to unmask]
Subject: ts480 menu settings
Here are the menu settings that relate to cw for the ts-480.
Enjoy comment and debate.
The menu button, just below the mode button has to be on, the up and = down
buttons change a setting=E2=80=99s options, and the click knob just = below
the up and down buttons rotates between the menus.
Here are the ts-480 menu setting description=E2=80=99s followed by my =
chosen settings.
33 Keying priority over playback Without switching off the repeat=20
32=20
playback for messages, you can start=20
keying.=20
My setting, is set to off, but I am thinking of experimenting with it.
34 CW RX pitch / TX sidetone=20
frequency=20
Select RX pitch frequency between=20
400Hz and 1000Hz. At the same time,=20
sidetone frequency changes with the=20
pitch frequency. This can be used to=20
zero in on a target signal by matching=20
the sidetone frequency with the RX=20
beat.=20
My setting, 600.
35 CW keying weight ratio Change the dot/dash weight ratio. This is =
usually set to AUTO.=20
My setting, 3.1
36 Reverse CW keying auto=20
weight ratio=20
You can change the AUTO setting for=20
#35.=20
My setting is set to on.
37 Bug key function Manual TX can be enabled for dashes only.=20
My setting is turned to off. I could never run a bug.
38 Swap dot & dash paddle=20
position=20
Swap the paddle position to suit either=20
right-handed or left-handed use.=20
My setting, is turned to off. I key left handed backwards, I have = always
made dashes with my thumb.
Yes, a double negative is a positive!
39 Auto CW TX in SSB mode Automatically switch mode to CW transmission = by
simply operating the paddle.=20
CW=20
My setting, is turned to on. This is very handy!
40 Define CW tune frequency Useful if used in combination with #39,=20
as there is no need to operate the dial=20
to zero in on a target.=20
My setting, on.
|
