Thank you Alan and Steve and all. The audio recording that I had didn't
give the proper size of the smaller cushion that goes on the bottom of the
VGS1. The description that you all provided was just what I needed. Thank
you,
Kent KK4FFF
Clyde NC
-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Alan R. Downing
Sent: Monday, November 18, 2013 11:39 PM
To: [log in to unmask]
Subject: Installing the voice chip in the 590
Following is the instructions that my friend Steve, N9HE, gave me. He just
installed the chip/board in his 590. I hope this helps:
Remove the bottom cover then remove the shield cover. There are 5 rubber
cushions in the VGS-1 package. Use the 2 rubber cushions sized 20x30x2mm
and 21x21x2.5mm. Attach the larger pad on top of the VGS-1 and the smaller
pad on the bottom of the VGS-1. The remaining cushions are not used. Plug
in the VGS-1 and replace the shield cover then replace bottom cover.
73
KD7GC
Alan R. Downing
Phoenix, AZ