Mime-Version: |
1.0 (Apple Message framework v1283) |
Content-Type: |
text/plain; charset=us-ascii |
Date: |
Tue, 26 Nov 2013 12:23:08 -0700 |
Reply-To: |
|
Subject: |
|
From: |
|
Message-ID: |
|
In-Reply-To: |
<DB.17.10505.9B6E4925@louvi-msg> |
Content-Transfer-Encoding: |
quoted-printable |
Sender: |
|
Parts/Attachments: |
|
|
I would, as a matter of course, install a ground rod and tie all your equipment to that. tying to the electrical ground may not be as helpful, especially if that ground is longer than a significant fraction of a wavelength on the band you are operating on. On 10 meters, a 9 foot run is nearly all of a quarter wave (and will act as an impedance transformer), thus creating RF hot spots on your equipment. I had to do this recently myself because some RF caused some components in my HF rig to fail (thus requiring repair). I refer you to the ARRL Antenna Handbook, specifically the sections on grounding.
-eric
On Nov 26, 2013, at 11:21 AM, Mike Ryan wrote:
> Hi all:
>
> This week I'm having perminant electrical service installed in our cottage
> and proper grounding for sat/cbl services is being taken into account,
> along with my station, to be grounded in the electrical pannel.
> Will I still require the use of either the drounding studs on the back of
> my rig or ATU?
>
> TNX 73:
> Michael DE VO1AX
|
|
|