Howard thanks for the info and it gives me a good start.
-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Howard Kaufman
Sent: Sunday, December 29, 2013 4:48 AM
To: [log in to unmask]
Subject: Re: Amplifier tuning
First of all, back off the drive until you get the hang of it.
2. Tune the antenna.
3. Turn the amp on, peak the tune, and crank up the plate, until the
output doesn't go up any more, re-tune the plate. Bring up the drive and
check the tune again to be sure it is peaked.
At least that's an old pi network. I can't believe I remember this stuff.
Depending on the amp, it might be simpler.
---
This email is free from viruses and malware because avast! Antivirus
protection is active.
http://www.avast.com