Tom,
Turning down the RF gain is a good idea and turning off the AGC, if
possible, is an even better one. Of course, the AGC activity would make it
difficult if not impossible to hear the null. I turn mine off when trying
to orient the beam on a signal but I know not every rig has this function
available. Good luck.
Lou Kolb
Voice-over Artist:
Radio/TV Ads, Video narrations
Messages On-hold:
www.loukolb.com
----- Original Message -----
From: "Tom Behler" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Wednesday, January 01, 2014 11:22 AM
Subject: Re: MFJ Noise Bridge Again
> Howard:
>
> I think I'll have to back the RF gain down on the TS480 at least somewhat
> in
> order to effectively work with the noise bridge, based on my limited
> experience with the device and my TS590. Adjusting the RF gain on the 480
> is, of course, a bit of a hassle, since you have to do it via the front
> panel keypad and function knob, rather than a simple single knob
> adjustment,
> but it is doable. I seem to recall it is number 6, but will have to check
> the manual.
>
> In any case, I'm not going to go out into the RV today and try it, since
> temps are in the single digits, wind chills are below 0, and since I'd
> have
> to trudge through at least 12 inches of snow to get there. (grin)
>
> Tom Behler: KB8TYJ
>
>
> -----Original Message-----
> From: For blind ham radio operators [mailto:[log in to unmask]]
> On Behalf Of Howard Kaufman
> Sent: Wednesday, January 01, 2014 11:11 AM
> To: [log in to unmask]
> Subject: Re: MFJ Noise Bridge Again
>
> Tom, you got it right!
> The minimum pulse is very accurate. Any additional circuitry adds loss.
> I am not sure if you can just attenuate the signal while listening on the
> 480, or if you will have to crank the rf gain back as well.
>
>
> ---
> This email is free from viruses and malware because avast! Antivirus
> protection is active.
> http://www.avast.com
|