Lowell:

That's exactly what I'm thinking here if I use the Noise Bridge at the home
QTH.

I'd put the noise bridge between the TS590 and the amplifier.

At the RV, of course, there's no amplifier to go with the TS480, so excess
power would not be a concern.

Tom Behler: KB8TYJ


-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Lowell Miller
Sent: Wednesday, January 01, 2014 11:57 AM
To: [log in to unmask]
Subject: Re: Using MFJ Noise Bridge To Determine Antenna Resonant Frequency

Tom, I have my 212 between the TS2000 and the amplifier.
I would not want to put the 212 in danger with the output of the amp.
Happy New Year and 73.
Lowell  W8QIY
----- Original Message ----- 
From: "Tom Behler" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Wednesday, January 01, 2014 11:25 AM
Subject: Re: Using MFJ Noise Bridge To Determine Antenna Resonant Frequency


> Howard:
>
> I guess I get this, but wouldn't you have to put the tuner in the bypass
> position?
>
> I can do this with my Tentech 238A manual tuner in the shack, but the MFJ
> 901B manual tuner I would use in the RV does not have a bypass position, 
> at
> least so far as I know.
>
> Tom Behler: KB8TYJ
>
>
> -----Original Message-----
> From: For blind ham radio operators [mailto:[log in to unmask]]
> On Behalf Of Howard Kaufman
> Sent: Wednesday, January 01, 2014 11:13 AM
> To: [log in to unmask]
> Subject: Re: Using MFJ Noise Bridge To Determine Antenna Resonant 
> Frequency
>
> Set the bridge and tune a receiver until the pulses minimum is heard. 
> Kind
> of looking for a needle in a haystack.
>
>
> ---
> This email is free from viruses and malware because avast! Antivirus
> protection is active.
> http://www.avast.com