When I switched mine from the ts480 to the ts590, I just left the
pads that were there on both sides of the board and put the vgs1 board in.
It works, so far.
Mike Barnard
KD2CDUAt 10:14 PM 11/18/2013, you wrote:
>Kent, you use two of the pads. If there still in the pack, it's the second
>and the forth down from the large one. The large one say, no.1 and then
>down you would use 2 and 4 and they both go on top under the cover that you
>must take off with the four screws. That's all I can say with my X Y L's
>discription hi hi . G L 73
>Ed K7UC
>
>--------------------------------------------------
>From: "Steve Forst" <[log in to unmask]>
>Sent: Monday, November 18, 2013 7:52 PM
>To: <[log in to unmask]>
>Subject: Re: installing VGS1 on TS-590
>
> > The manual does say to use 2 foam pads and the other 3 are not used,
> > but the description isn't very clear on the placement. It does say to
> > attach them to the vgs-1, so maybe one goes on each side? If you
> > can't find someone to look at the picture or drawing or whatever is on
> > page 71 of the print manual, maybe a little trial and error is in order
> > and see what fits best.
> >
> > Sorry I can't be of more help, but I had mine installed at HRO and never
> > had my hands in there.
> >
> > 73, Steve KW3A
> >
> >
> >
> > On 11/18/2013 9:28 PM, Howard, W A 9 Y B W wrote:
> >> Kent,
> >>
> >> I'm not sure you use the foam blocks in the 590. I don't remember using
> >> them when mine was installed. Keep in mind that that board goes in more
> >> then one model and the foam may be used in another model.
> >>
> >> Howard #3
> >>
> >> ----- Original Message -----
> >> From: "Kent Plemmons" <[log in to unmask]>
> >> To: <[log in to unmask]>
> >> Sent: Monday, November 18, 2013 6:03 PM
> >> Subject: installing VGS1 on TS-590
> >>
> >>
> >>> Good evening list,
> >>>
> >>>
> >>>
> >>> Can anyone instruct me regarding placement of the two small cushions
> >>> that
> >>> install on the VGS1 synthesizer for the Kenwood TS-590S?
> >>>
> >>>
> >>>
> >>> I know where the VGS1 installs and I have the proper two cushions. I
> >>> don't
> >>> know if one cushion installs on each side of the VGS1 or if they both
> >>> install on the top of the synthesizer. Does anyone know?
> >>>
> >>>
> >>>
> >>> Thank you very much,
> >>>
> >>>
> >>>
> >>> Kent Plemmons
> >>>
> >>> Near Clyde NC
> >>>
> >>> KK4FFF
> >>>
> >>>
> >>>
> >>>
> >>
> >>
> >>
|
