The manual does say to use 2  foam pads and  the other 3 are not used, 
but the description isn't very clear on the placement.  It does say to 
attach them to the vgs-1, so  maybe one goes on each side?   If you 
can't find someone to look at the picture or drawing or whatever is on 
page 71 of the print manual, maybe a little trial and error is in order 
and see  what fits best.

Sorry I can't be of more help, but I had mine installed at HRO and never 
had my hands in there.

73, Steve KW3A



On 11/18/2013 9:28 PM, Howard, W A 9 Y B W wrote:
> Kent,
>
> I'm not sure you use the foam blocks in the 590.  I don't remember using
> them when mine was installed.  Keep in mind that that board goes in more
> then one model and the foam may be used in another model.
>
> Howard #3
>
> ----- Original Message -----
> From: "Kent Plemmons" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Monday, November 18, 2013 6:03 PM
> Subject: installing VGS1 on TS-590
>
>
>> Good evening list,
>>
>>
>>
>> Can anyone instruct me regarding placement of the two small cushions that
>> install on the VGS1 synthesizer for the Kenwood TS-590S?
>>
>>
>>
>> I know where the VGS1 installs and I have the proper two cushions.  I
>> don't
>> know if one cushion installs on each side of the VGS1 or if they both
>> install on the top of the synthesizer.  Does anyone know?
>>
>>
>>
>> Thank you very much,
>>
>>
>>
>> Kent Plemmons
>>
>> Near Clyde NC
>>
>> KK4FFF
>>
>>
>>
>>
>
>
>