You can't mess up the jumper block for the ts-2000, it's the outer 3 wires 
on each end of the block so it would be the same either way with the chip. 
They just go straight across to the hole right next to each other. Make sure 
the power button is on for the signalink, in is on.
----- Original Message ----- 
From: "Steve Forst" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, June 17, 2013 4:05 PM
Subject: Re: signalink


> Are you sure the jumper block is installed  right and that it is the
> right one?  Some time ago I had a jumper for the 480  in backwards and
> had the same result.
>
> If I remember right, you are going into a TS-2000.  Are you going in via
> the 13  pin din plug on the rear?  Is everything plugged in correctly?
>
> 73, Steve KW3A
>
> On 6/17/2013 3:46 PM, DAN REID wrote:
>> It is putting out a  steady carrier. =20
>>    ----- Original Message -----=20
>>    From: Steve Forst<mailto:[log in to unmask]>=20
>>    To: =
>> [log in to unmask]<mailto:[log in to unmask]>=20
>>    Sent: Monday, June 17, 2013 1:43 PM
>>    Subject: Re: signalink
>>
>>
>>    Dan,
>>
>>    Not familiar with all of this software, but what do you mean when 
>> you=20
>>    say "all I get is a straight carrier"?
>>
>>    Is the rig going into TX and  putting out a steady
>>    carrier, or  are you hearing  a constant  tone  on RX?
>>
>>    73, Steve KW3A
>>
>>    On 6/17/2013 3:34 PM, DAN REID wrote:
>>    > digipan, echo link, ham radio deluxe, mixw, mmtty and with the n3fjp 
>> =
>> =3D
>>    > software.
>>    >   Same results for all of them.  arrg!=3D20
>>    > Dan (kb6unc)=3D20
>>    >    ----- Original Message -----=3D20
>>    >    From: Steve =
>> Forst<mailto:[log in to unmask]>=3D20<mailto:[log in to unmask]>
>>    >    To: =3D
>>    > =
>> [log in to unmask]<mailto:[log in to unmask]>=3D20<=
>> mailto:[log in to unmask]:[log in to unmask]
>> RG%3E=3D20>
>>    >    Sent: Monday, June 17, 2013 5:45 AM
>>    >    Subject: Re: signalink
>>    >
>>    >
>>    >    What software are you using?
>>    >
>>    >    73, Steve KW3A
>>    >
>>    >    On 6/16/2013 9:27 PM, DAN REID wrote:
>>    >    > Does anyone have any helpful hints as to how to get activity =
>> through =3D
>>    > the =3D3D
>>    >    > signalink? I've set both input and output to the usb speakers =
>> and =3D
>>    > mic, =3D3D
>>    >    > but all I get is a straight carrier.  thanks,
>>    >    > dan (kb6unc)
>>    >    >
>>    >    >
>>    >    >
>>    >
>>    >
>>    >
>>
>>
>>