Are you sure the jumper block is installed  right and that it is the 
right one?  Some time ago I had a jumper for the 480  in backwards and 
had the same result.

If I remember right, you are going into a TS-2000.  Are you going in via 
the 13  pin din plug on the rear?  Is everything plugged in correctly?

73, Steve KW3A

On 6/17/2013 3:46 PM, DAN REID wrote:
> It is putting out a  steady carrier. =20
>    ----- Original Message -----=20
>    From: Steve Forst<mailto:[log in to unmask]>=20
>    To: =
> [log in to unmask]<mailto:[log in to unmask]>=20
>    Sent: Monday, June 17, 2013 1:43 PM
>    Subject: Re: signalink
>
>
>    Dan,
>
>    Not familiar with all of this software, but what do you mean when you=20
>    say "all I get is a straight carrier"?
>
>    Is the rig going into TX and  putting out a steady
>    carrier, or  are you hearing  a constant  tone  on RX?
>
>    73, Steve KW3A
>
>    On 6/17/2013 3:34 PM, DAN REID wrote:
>    > digipan, echo link, ham radio deluxe, mixw, mmtty and with the n3fjp =
> =3D
>    > software.
>    >   Same results for all of them.  arrg!=3D20
>    > Dan (kb6unc)=3D20
>    >    ----- Original Message -----=3D20
>    >    From: Steve =
> Forst<mailto:[log in to unmask]>=3D20<mailto:[log in to unmask]>
>    >    To: =3D
>    > =
> [log in to unmask]<mailto:[log in to unmask]>=3D20<=
> mailto:[log in to unmask]:[log in to unmask]
> RG%3E=3D20>
>    >    Sent: Monday, June 17, 2013 5:45 AM
>    >    Subject: Re: signalink
>    >
>    >
>    >    What software are you using?
>    >
>    >    73, Steve KW3A
>    >
>    >    On 6/16/2013 9:27 PM, DAN REID wrote:
>    >    > Does anyone have any helpful hints as to how to get activity =
> through =3D
>    > the =3D3D
>    >    > signalink? I've set both input and output to the usb speakers =
> and =3D
>    > mic, =3D3D
>    >    > but all I get is a straight carrier.  thanks,
>    >    > dan (kb6unc)
>    >    >
>    >    >
>    >    >
>    >
>    >
>    >
>
>
>