Howard:

This is tremendously helpful, and I hope others on the list will benefit 
from what you are sharing here as well.

These things are not always obvious with the various rigs right out of the 
box.

Thanks so much!

73 from Tom Behler: KB8TYJ

----- Original Message ----- 
From: "Howard, W A 9 Y B W" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Tuesday, August 07, 2012 11:38 PM
Subject: Re: Need Tips for easily removing DC power cord connection on 
back-up Kenwood TS570 rig


> Tom,
>
> Let me try to help you with the power connector plug for your TS570 and
> TS590.
>
> First, the connector for the 570 is a six position connector, however, 
> only
> 4 of the six positions are used.  Only the left two columns are used as
> viewed from the front of the radio.
>
> The connector for the 590 is a 4 position connector and all 4 are used.
>
> Next, the place where you need to press in order to remove the connector 
> is
> at different places on the respective connectors.
>
> On the 570 do the following:
>
> With the front of the radio facing you, on the top of the connector locate
> the tab that can be depressed.  The tab is located on the top of the
> connector, in the center, left-to-right just above the wire on the right 
> in
> the top row of wires.
>
> The tab is on top at the back of the plug just above the right most wire.
>
> Put your index finger on the bottom of the plug and the tip of your thumb 
> on
> the tab and squeeze and pull back away from the radio.
>
> The best way to see how this locking thingie works is to unplug the plug 
> and
> examine it as you squeeze the connector as described above.
>
> For the 590 the place where you squeeze is located toward the front of the
> plug instead of the back, and it is not as obvious and does not depress as
> much.
>
> Again, examine the plugs while disconnected while you squeeze so as to see
> how they work.
>
> The plug for the 570 is easier to work and I can squeeze using my thumb 
> and
> little finger to remove it.  It is that easy once you understand how it
> works.
>
> I hope this helps.
>
> 73
>
> Howard #3
>
> ----- Original Message ----- 
> From: "Tom Behler" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Sunday, August 05, 2012 5:51 PM
> Subject: Need Tips for easily removing DC power cord connection on back-up
> Kenwood TS570 rig
>
>
>> Hi, again, everyone.
>>
>> I was doing some testing of the Kenwood TS570 that I bought earlier this
>> summer as a back-up to my TS590, and I am finding that it is extremely
>> difficult to remove the DC power connector from the back of that rig.
>> Actually, I have found the same problem with my TS590, and the TS480 out
>> at
>> the RV.
>>
>> Does anyone have any suggestions for removing the DC power connector
>> easily?
>> I know there is a small clip on the top of the connector that fits into
>> the
>> housing, but I am having trouble figureing out how to consistently
>> disengage
>> it.  I just don't want to damage anything.
>>
>> 73 from Tom Behler: KB8TYJ
>