Gary,
It's been a long time since I worked with a 386 so I'm not sure about
the BIOS, but I don't believe it checks for anything in the high memory
area.
DOS will never see or use anything above 1Meg of RAM. If you have
applications that need the upper memory, then you must use the EMM386
driver in the config.sys file to gain access to that 4Meg
Jim Meagher
=====
Micro Solutions Consulting Member of The HTML Writers Guild
http://www.ezy.net/~microsol International Webmasters Association
=====
> -----Original Message-----
> From: PCBUILD - Personal Computer Hardware discussion List
> [mailto:[log in to unmask]]On Behalf Of gary tennesen
> Sent: Thursday, September 17, 1998 9:20 PM
>
> I was working on an old motherboard that serves as a DOS gateway to a
> remote server. The network card had gone bad and I replaced. Big
> question is though, this 386dx 40mhz had 4mb ram and both DOS AND the BIOS
> were only reporting the 640k. There was no upper memory reported in the
> AmiBIOS or in Dos!
>
-----
**Need help with PCBUILD mailing list? Send an Email to:**
Bob Wright<[log in to unmask]> or Drew Dunn<[log in to unmask]>