Subject: | |
From: | |
Reply To: | |
Date: | Wed, 25 Jul 2012 12:14:43 -0400 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
I might be inclined to say take the voice chip out and try reseating it.
----- Original Message -----
From: "Steve Forst" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Wednesday, July 25, 2012 11:39 AM
Subject: Re: TS 480 sat is dead
> It's always possible it's DOA, but you should recheck everything a few
> times just to be sure you aren't overlooking something.
>
> I would do a full reset:
>
> Press and hold A=B key while turning on the power. A conformation
> message should come up on the display (don't remember if any voice
> output on this), hit the a=b key again to confirm the reset. Hitting
> any other key will abort reset.
>
> Good luck, Steve KW3A
>
> On 7/25/2012 11:21 AM, Robert C wrote:
>> Brand new, all I did was install the voice chip. Finally got around to
>> having help with antennas and went to turn on the rig. Dead. We checked
>> all the obvious things. Power is getting into the radio. Swapped the
>> cable that connects the remote head to the tx/rx unit.
>>
>> I will have to contact Kenwood and see about sending it back in for
>> warranty work. In the meantime, has anyone had this happen?
>>
>> Quote of the nanosecond...
>> I saw a subliminal advertising executive, but only for a second.
>> Robert & Dreamer Doll ke7nwn
>> E-mail-
>> [log in to unmask]
>> Home Page-
>> http://webpages.charter.net/dog_guide/
>>
>>
>>
|
|
|