Hello, all.

Well, as some of you know, I recently purchased a Kenwood TS570S from the 
local estate sale of a silent key friend in our club.

I just received the VS3 voice chip for the rig, and hope to install it this 
week-end, if I get enough grading of papers done in advance of finals week 
at the University next week.

If I get the VS3 installed, I may just try the TS570 out over the week-end, 
although whether that actually happens remains to be seen.

Anyway, I was wondering if I could use the same amplifier interface cable 
with the TS570 that I now use for the TS590?  I also have an amplifier cable 
for the TS480, so perhaps that would work as another alternative.

Thanks for any insights on this. ... I just don't want to do anything wrong 
here, since I know different rigs require different pin configurations for 
their interface cables.

73 from Tom Behler: KB8TYJ