Tom,

I'm pretty sure the cable for the 480 won't work because it won't even fit. 
I don't know about the one for the 590.

Steve

----- Original Message ----- 
From: "Tom Behler" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Thursday, April 26, 2012 21:26
Subject: amplifier connections for TS570


> Hello, all.
>
> Well, as some of you know, I recently purchased a Kenwood TS570S from the
> local estate sale of a silent key friend in our club.
>
> I just received the VS3 voice chip for the rig, and hope to install it 
> this
> week-end, if I get enough grading of papers done in advance of finals week
> at the University next week.
>
> If I get the VS3 installed, I may just try the TS570 out over the 
> week-end,
> although whether that actually happens remains to be seen.
>
> Anyway, I was wondering if I could use the same amplifier interface cable
> with the TS570 that I now use for the TS590?  I also have an amplifier 
> cable
> for the TS480, so perhaps that would work as another alternative.
>
> Thanks for any insights on this. ... I just don't want to do anything 
> wrong
> here, since I know different rigs require different pin configurations for
> their interface cables.
>
> 73 from Tom Behler: KB8TYJ
>