Hi Gary,

I've noticed that about quite a few of Scott's programs.  My solution has
been to type in a fake call, then press Escape to clear the field.  From
then on it seems to work fine.

Great work in the contest by the way!  I'm sorry I missed you.

Take care and very 73. 


 
Kevin :)
Amateur Radio:  K7RX
 

-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Gary Smith
Sent: Sunday, February 26, 2012 16:28
To: [log in to unmask]
Subject: MS QSO Party

Thanks to everyone who worked me during the Mississippi QSO Party contest.
I worked a little over six hours and made 333 contacts which seven of them
were DX.  I'm not sure how good that is since this was my first time to do
the QSO Party contest.  What I do know is that it was a lot of fun.    
I was using the N3FJP logging software and had a few problems.  It seems
like this was discussed some time back and I was wondering if there were any
solutions?  The first field, where you type the callsign in, sometimes it
wouldn't type the first letter and the same thing would happen in the field
where you type the state or country.  The second problem was when after you
would put everything in and press enter sometimes the info wouldn't enter
into the log and I would have to delete the call out and retype it back in.
Then when you press enter it would go in.  Has anyone else had this problem
and if so did you find a solution?         

73, Gary, N5GD