Hi Tom,
I would have to agree with the majority of the others who have responded.
The fact he used the grease and then the tape should do a fine job for you.
I wouldn't worry about it at all.
Take care and very 73.
Kevin :)
Amateur Radio: K7RX
-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Tom Behler
Sent: Friday, October 21, 2011 19:30
To: [log in to unmask]
Subject: Small dilemma; Need some advice
Hi, all.
Well, to make a very long story short, I have decided to take my troublesome
Carolina Windom 160 compact antenna down, and am in the process of replacing
it with a 160-meter sloper, and an 80-meter sloper that I purchased at a
swap in my area last week-end.
We are in the middle of the antenna replacement process, but I'm hoping it
should be done by later tomorrow.
All has gone well, except for one small issue, which I'm torn about how to
deal with. This is the kind of issue where we've all been there when trying
to deal with volunteer help who doesn't do things like we would.
Anyway, my friend installed the 160-meter sloper at the top of my 40-foot
mast, but when I asked him how he sealed the coax connection at the feed
point, he said that he coated the connector with a dialectric grease, and
then tightly wrapped three layers of electrical tape around the connection.
The tape he used was some real good 3 M tape that I had gotten a while ago.
I had wanted him to put coax seal on top of the tape, but he would not do
it, arguing that what he did should be fine.
Obviously, my concern is that the electrical tape eventually will
deteriorate, and let water into the connection.
I'm trying to figure out a tactful way to bring up this issue again with him
when he comes back tomorrow, but, at the same time, I don't want to offend
him, since he has done so much for me already.
Does anyone have any ideas as to how to tactfully handle the situation?
Obviously, if just having the electrical tape was good enough, I wouldn't
stress about it, but I would sure hate to be introducing unnecessary
problems into the situation here.
73 from Tom Behler: KB8TYJ
|