describe these buttons again, not following when you say to the right of the
big know.
there is a keypad there on the 590.
 

-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Ed Malmgren
Sent: Monday, August 15, 2011 11:25 PM
To: [log in to unmask]
Subject: Fw: ts50 question on memory channels

Jed, when you go to the third row down to the right of the big knob, push
the first button and select your channel then go to the right and push the
third button on that row and you will hear a long note and then it will
tune.  73  good luck.  73
Ed   K7UC

--------------------------------------------------
From: "Jed Barton" <[log in to unmask]>
Sent: Monday, August 15, 2011 8:43 PM
To: <[log in to unmask]>
Subject: ts50 question on memory channels

> Hey guys,
> I have programmed in several memory channels to the 590.  However i 
> notice when i go to these channels you can't turn the vfo it doesn't go
anywhere.
> Is there a setting where i can change this?
>
> Thanks,
> Jed