Tom,
There are several files in the root directory whose names are model numbers
of rigs. Currently the extensions of the files end as ".ri". There is only
one file for Kenwood rigs. You must rename the file you want to use from
".ri" to ".rig". Only one file can be renamed at a time.
Hope this helps.
73's
Howard #3
are
----- Original Message -----
From: "Tom Behler" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, December 19, 2011 9:18 PM
Subject: WhiteStick Log Question
> Hi, folks.
>
> Well, I believe I successfully installed WhiteStick log on my Windows 7
> laptop.
>
> I didn't think it would work, but the program seems to be there. It seems
> to
> function well, and is extremely Jaws friendly.
>
> So, thanks to Howard number 3 for posting the link.
>
> I do have one question, though.
>
> Where do you find the Cat Rig Control set-up in the software?
>
> It is clear from the text below in the Instructions folder that you can
> configure the software to work with your rig, but I can't find where to go
> to configure things.
>
> Here are the instructions. Can anyone help?:
>
> CAT RIG CONTROL.
> CAT rig control will be provided if you change the extension of one of the
> .RI files
> provided to .RIG
> It is important that only one of these files has the extension .RIG
> When you change frequency or mode on the rig WSLog will update the
> computer.
> FT990 users must have revision one point three firmware or higher to
> function correctly.
> You may amend line one in the rig file; the first number is the COM port,
> followed by the baud rate, parity (N), number of data bits and number of
> stop bits.
> Alter these if they are not the rig defaults.
> The com port number must be followed by a colon.
> A general purpose ICOM rig file is provided, users will need to change the
> digits
> marked xx to the address of the rig as supplied in the rig manual. These
> values
> are hexadecimal, only use the two digits, ignore the H.
> A KENWOOD file provides for all Kenwood rigs.
> Users of Yaesu FT817, FT847, FT857 and FT897 should use the FT8x7 file.
> Users of Yaesu FT450, FT950, FT2000 and FTDX9000 should use the YAESU1
> file.
> CAT control is also provided for the TEN-TEC Pegasus rig.
> The RIG file for that contains one line for the drive and path of the
> Pegasus software.
> This is typically C:\PEGASUS\ and the last character MUST be a back slash.
>
> 73 from Tom Behler: KB8TYJ
|