Hi Scott,
Did you download the virtual com port driver from Kenwood's web site and
install it first? You will need to do that before you can get the USB to
work properly.
Take care and very 73.
Kevin :)
Amateur Radio: K7RX
-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Scott Howell
Sent: Wednesday, December 21, 2011 16:56
To: [log in to unmask]
Subject: Aether, Mac, and TS590S
Hi folks,
Well I decided to try MacloggerDX and that interface was a little to =
much and lots of unlabeled buttons. In any case I ended up grabbing a =
demo of Aether and the interface for a VoiceOver user is great and very =
accessible. However, I cannot get my TS590S talking to the software via =
USB.
I set the rig control on, chose the correct manufacturer and model, and =
initially the serial port was "none", but I had to mess with it and now =
I only see "HWGBraillant4035000572--1." For the record I do not have a =
Brailliant Braille display. I do have a Refreshabraille, but it is not =
connected, so not sure why Aether sees that USB driver as a serial port. =
That may be the issue I am not sure. I did set the TS590S menu number 63 =
to USB, 61 is set to 9600, and 62 is set at 115,200.
So, does anyone have any suggestions on how I can get this to work?
Oh and yes I did look for help in the help section and searched via =
Google, but found nothing that addresses my problem.
THanks,
73
Scott/N3BYY=
|