Sender: |
|
Date: |
Fri, 12 Jun 1998 16:06:32 -0700 |
Reply-To: |
|
Subject: |
|
MIME-Version: |
1.0 |
Content-Transfer-Encoding: |
7bit |
In-Reply-To: |
|
Content-Type: |
text/plain; charset="iso-8859-1" |
From: |
|
Parts/Attachments: |
|
|
You would have to look at the specs for each drive you intend
to use. Each manufacturer has a spec page on the web as well
as a label on the drive itself.
IN GENERAL.... a SCSI drive will draw around 1 1/2 to 2 amps
while running but they have a peak (the initial uuummph to get
the spindle motor and platters spinning) of about 4-5 amps.
(Not to change the subject, but that is a good reason for not
shutting off a PC -- it reduces the strain on the Power supply).
I suppose that a low-end builder of power supplies might scrimp
and save a penny or two by using an undersized wire which could
result in the situation that David spoke of. I think that as long
as you use UL and CSA listed components, you should not have any
problem putting two drives on a "Y-ed" cable
Although, as a matter of caution, I always try to mate a hard drive
with a floppy or CD if I need to split a cable.
Jim Meagher
=====
Micro Solutions Consulting Member of The HTML Writers Guild
http://www.ezy.net/~microsol International Webmasters Association
=====
> -----Original Message-----
> From: PCBUILD - Personal Computer Hardware discussion List
> [mailto:[log in to unmask]]On Behalf Of Eric Sabo
> Sent: Friday, June 12, 1998 7:28 AM
>
> Do you know of any web sites related to this? I'm
> rebuilding a server
> that I have and I would like to know a ballpark figure on how
> many drives I
> could put in this box without blowing out a power supply.
>
|
|
|