yep, it was, i just typed it wrong in the subject, ooooooops.
all set now though 

-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Ed Malmgren
Sent: Monday, August 15, 2011 11:51 PM
To: [log in to unmask]
Subject: Fw: ts50 question on memory channels

    Sorry Jed, I thought it was the 590 you were talking about.  73
Ed   K7UC

--------------------------------------------------
From: "Jed Barton" <[log in to unmask]>
Sent: Monday, August 15, 2011 9:34 PM
To: <[log in to unmask]>
Subject: Re: ts50 question on memory channels

> describe these buttons again, not following when you say to the right 
> of the big know.
> there is a keypad there on the 590.
>
>
> -----Original Message-----
> From: For blind ham radio operators [mailto:[log in to unmask]]
> On Behalf Of Ed Malmgren
> Sent: Monday, August 15, 2011 11:25 PM
> To: [log in to unmask]
> Subject: Fw: ts50 question on memory channels
>
> Jed, when you go to the third row down to the right of the big knob, push
> the first button and select your channel then go to the right and push the
> third button on that row and you will hear a long note and then it will
> tune.  73  good luck.  73
> Ed   K7UC
>
> --------------------------------------------------
> From: "Jed Barton" <[log in to unmask]>
> Sent: Monday, August 15, 2011 8:43 PM
> To: <[log in to unmask]>
> Subject: ts50 question on memory channels
>
>> Hey guys,
>> I have programmed in several memory channels to the 590.  However i
>> notice when i go to these channels you can't turn the vfo it doesn't go
> anywhere.
>> Is there a setting where i can change this?
>>
>> Thanks,
>> Jed