Sounds good Jed.
73  Ed   K7UC

--------------------------------------------------
From: "Jed Barton" <[log in to unmask]>
Sent: Monday, August 15, 2011 10:01 PM
To: <[log in to unmask]>
Subject: Re: ts50 question on memory channels

> yep, it was, i just typed it wrong in the subject, ooooooops.
> all set now though
>
> -----Original Message-----
> From: For blind ham radio operators [mailto:[log in to unmask]]
> On Behalf Of Ed Malmgren
> Sent: Monday, August 15, 2011 11:51 PM
> To: [log in to unmask]
> Subject: Fw: ts50 question on memory channels
>
>    Sorry Jed, I thought it was the 590 you were talking about.  73
> Ed   K7UC
>
> --------------------------------------------------
> From: "Jed Barton" <[log in to unmask]>
> Sent: Monday, August 15, 2011 9:34 PM
> To: <[log in to unmask]>
> Subject: Re: ts50 question on memory channels
>
>> describe these buttons again, not following when you say to the right
>> of the big know.
>> there is a keypad there on the 590.
>>
>>
>> -----Original Message-----
>> From: For blind ham radio operators 
>> [mailto:[log in to unmask]]
>> On Behalf Of Ed Malmgren
>> Sent: Monday, August 15, 2011 11:25 PM
>> To: [log in to unmask]
>> Subject: Fw: ts50 question on memory channels
>>
>> Jed, when you go to the third row down to the right of the big knob, push
>> the first button and select your channel then go to the right and push 
>> the
>> third button on that row and you will hear a long note and then it will
>> tune.  73  good luck.  73
>> Ed   K7UC
>>
>> --------------------------------------------------
>> From: "Jed Barton" <[log in to unmask]>
>> Sent: Monday, August 15, 2011 8:43 PM
>> To: <[log in to unmask]>
>> Subject: ts50 question on memory channels
>>
>>> Hey guys,
>>> I have programmed in several memory channels to the 590.  However i
>>> notice when i go to these channels you can't turn the vfo it doesn't go
>> anywhere.
>>> Is there a setting where i can change this?
>>>
>>> Thanks,
>>> Jed