I have version 11 and when I do the insert shift r I here  "reply to sender" 
however  then I here" for blind ham radio operators "
it does not show your name. up at the top.
Pierre
----- Original Message ----- 
From: "Ron Canazzi" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Wednesday, June 22, 2011 10:59 AM
Subject: Re: for the list serve Monitor


> Hi Pierre,
>
> This keystroke is only in a relatively recent version of JAWS.  If you 
> have
> a very old version--such as  before 8.0, it will not work.  Also, make 
> sure
> you firmly hold down the insert and shift key before you press the r.  It
> must be done from within the open message.
>
> ----- Original Message ----- 
> From: "Pierre Berube" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Wednesday, June 22, 2011 9:21 AM
> Subject: Re: for the list serve Monitor
>
>
> I did  the insert shift plus r  and it still goes to the blind-operators
> list address it did not show  Steve Dresser...
> Pierre
> k9eye
> ----- Original Message ----- 
> From: "Steve Dresser" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Wednesday, June 22, 2011 9:45 AM
> Subject: Re: for the list serve Monitor
>
>
>> Pierre,
>>
>> If you're using JAWS, Insert+Shift+R will reply directly to the sender of
>> the message.  There may be a similar command for WindowEyes, but I don't
>> know what it is.
>>
>> Steve
>>
>> ----- Original Message ----- 
>> From: "Pierre Berube" <[log in to unmask]>
>> To: <[log in to unmask]>
>> Sent: Wednesday, June 22, 2011 08:29
>> Subject: for the list serve Monitor
>>
>>
>>> Ok, there is no such thing as a stupid question...
>>>
>>> Why, does this list does not have a option at the end of  a thread to do
>>> =
>>> the following..
>>>
>>> 1: reply to original sender
>>>
>>> 2: write and post a new subject
>>>
>>> 3: reply to the group
>>>
>>> or is there a command I do not know  that I should know.
>>>
>>> since I would like to reply to the person that originated  the thread.
>>>
>>>
>>>
>>> 73
>>>
>>> Pierre
>>>
>>> k9eye
>>>