Thanks again, Steve and everyone.

Be assured that I continue to read the thread on this issue with interest.

73 from Tom Behler:  KB8TYJ

----- Original Message ----- 
From: "Steve Dresser" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, February 28, 2011 8:41 PM
Subject: Re: RFI Saga continued


Tom,

You don't even have to turn it on.  In fact, you don't even have to unplug
it until you start to open it up.  The bleeder resistors will discharge the
caps a few seconds after you turn it off.

Steve

----- Original Message ----- 
From: "tom behler" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, February 28, 2011 18:54
Subject: Re: RFI Saga continued


>    The other thing I was thinking of doing was unplugging the power
> supply,
> letting it set for a while, and then turning the switch on, in the hopes
> that this would help discharge the capacitors too.
>
> Any thoughts?
>
> 73 from Tom Behler:  KB8TYJ
>
> ----- Original Message ----- 
> From: "Butch Bussen" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Monday, February 28, 2011 11:57 AM
> Subject: Re: RFI Saga continued
>
>
> The thing will discharge itself if you let it set a short while.  Second,
> there is only 24 volts or so on a cap and I've worked on them hot and as
> long as you stay out of the primary 110 side, no worries.  It won't zap
> you.
> 73
> Butch
> WA0VJR
>