It's been a while since I've tinkered around with this program. If you have
a Line in" on the soundcard, that is much preferred over the mic in. Under
the Windows volume control, be sure that whatever input port you are
using is selected, again the line in if available is better.
I don't know where you are getting the audio from the rig. If from a
speaker output, adjust with the rig's volume control. If from some din or
data port, you may have to use a menu. You can fine tune the audio
getting into the sound card by using the up and down slider on the input,
(again, either mic, or line in).
I don't remember what it means when digitalk says "buffer", but if you hear
it say "overload, that means you are putting too much audio into the
soundcard. Back it down with some combination of radio volume and sound
card volume controls. It might not hurt to try and get it to say
"overload", then you will be sure the radio's audio is really getting in.
Then back it down till it stops saying "overload".
Once you are sure audio is getting in, use the left and right arrow keys to
move up and down the band and lock on signals. Try keeping the filters
open wide on the rig.
73, Steve KW3A
----- Original Message -----
From: "Michael Ryan" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Friday, March 26, 2010 7:24 PM
Subject: Digitalk Help...P L E A S E
> Hi List:=20
>
> I need allot of help with digitalk.=20
> 1ST off, I don't have a clew on where to begin.=20
> I do have an audio cable connected to my mic input on my laptop just to =
> have a look and try some decoding.=20
> All I'm hearing from the digitalk is buffer, repeating. So it's =
> deffinitely receiving something.=20
> I don't know how to configure the soundcard, only the basic setup info =
> and there's nothing about configuring the default sondcard and playback =
> levels.=20
> Some beginning tips would be vary helpful.=20
>
>
> TNX & 73:=20
>
> Michael De VO1RYN=20
>
|