A little typo on my last one:
Part number for the cable to go from the RB 704 to the Kenwood is PNP 7D.
These cables are radio specific. The RB 704 buffer comes with 2 cables to
go from the unit to the amp.
No matter what sort of keying buffer, interface, or line you wind up with,
it will need the 7 pin din plug to mate with the 430.
73 Steve KW3A
----- Original Message -----
From: "Steve Forst" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, May 04, 2009 2:10 PM
Subject: Re: Upgraded to general, and a question.
> Rick,
>
> Just for starters:
>
> If you need the buffer between the rig and amp because the amps keying
> voltage is too high, look at the Ameritron RB 704 and the correct cable
> for your particular radio. I think it is the PNP 704. If I remember
> right, the 704 does not draw it's needed 12 vdc from the 430 like it does
> from most other rigs and you will need a wall wart.
>
> If it turns out that you don't need a buffer between rig and amp do a
> google search for W2ENY's home page. He sells a cable that has the 7 pin
> din on one end for the rig and the 2 RCA plugs at the other end for
> keying
> and ALC. He may have a buffer also, but not sure.
>
> There are other sources, but hope this gets you going in the right
> direction.
>
> 73, Steve KW3A
> ----- Original Message -----
> From: "Rick" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Monday, May 04, 2009 1:44 PM
> Subject: Re: Upgraded to general, and a question.
>
>
>>I don't plan to use the amp much until I get a auto tuner that can handle
>> high power.
>> I just mainly want to see if it works, or if it needs repaired.
>> It's been setting around here for a few years, and I don't know how long
>> it
>> was unused before I got it.
>> I plug it in to the wall out let and run it every now and then to try and
>> keep everything in good shape.
>> About the only thing I know about is it was built in 1976.
>> I still have the original manual and the manual for the 430s.
>> I'm really not sure of the names of the parts I need to Google it.
>> I tried looking for keying interface cable and had no luck.
>> I'm going to try to find a local ham who knows more about the subject
>> than
>> I
>> do, but That's hard to do around this area.
>> Most hams around here don't know me and don't seem to want to know me,
>> and
>> the ones that do are busy they barely have time to get on 2 meters now
>> and
>> then.
>> My call is KB3GOS.
>> Thanks again for your help and everybody else on the list.
>> 73
>
|