Kris:
I haven't gotten there yet, but there's an option in the software somewhere
that denotes weather or WX channels, and if you hit enter on that, it then
gets you into where those memories are, and then, you can arrange them
however you want.
If you can't find it, let me know. I hope to get back into the THF6A
software later today to finish the programming, but first, the antenna help
is coming, so that's my toppriority right now.
Again, though, let me know if you can't find that set of options, and I'll
get back to you later once I remember where it is myself.
73 from Tom Behler: KB8TYJ
----- Original Message -----
From: "Kris" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, September 07, 2009 1:10 PM
Subject: Re: THF6A programming question
Tom, Neither do I. So, how do you do that? So you are just rearranging the
order you get with the 4 key on the keypad? Sounds good. I'm in a spot
where I can get several rather strong stations and I'd like to have St.
Louis first.
Kris
----- Original Message -----
From: "T Behler" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, September 07, 2009 8:45 AM
Subject: Re: THF6A programming question
Kris:
See my earlier e-mail in response to Mike.
As I said there, I don't like the ordering they put the weather frequencies
in the radio at the factory, so I just re-do them from lowest to highest.
Takes me about 5 minutes.
73 from Tom Behler: KB8TYJ
----- Original Message -----
From: "Kris" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, September 07, 2009 8:54 AM
Subject: Re: THF6A programming question
Tom,
You do know that you have all seven weather frequencies already built-in on
the 6A radio? So that could save you some programming, but as for the 440
band, I can't help there.
Kris
----- Original Message -----
From: "T Behler" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Sunday, September 06, 2009 9:05 PM
Subject: THF6A programming question
Folks:
Well, now it's time to tap into your wisdom once again.
I'm trying to program my and my XYL's THF6a's, and have run into a bit of a
snag.
I'm using the programming software, and am trying to put all of the Boulder
CO area repeaters (both 2 meters and 440) on VFO A. I'd like to reserve VFO
B for the weather channels, tv channels, aircraft channels, and other public
service stuff.
I am doing fine with the 2 meter repeaters, but whenever I try to put a 440
repeater into a memory, the software automatically defaults back to 2
meters, whiping out whatever I've just done. I tried switching to VFO B.
for the 440 frequencies, but once I'm in VFO B., I can't seem to get back
into the memories.
Obviously, I'm doing something wrong here.
Can anyone help?
73 from Tom Behler: KB8TYJ
|