you could probably use a spot of appoxy to hold it in place if all else 
fails.
if not appoxy, since that is messy and tricky, any sort of good 
metal/plastic bonding glue will work I would imagine.
73
Colin, V A6BKX
----- Original Message ----- 
From: "T Behler" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Saturday, May 02, 2009 2:56 PM
Subject: problem with loose rotating clip on back of SMC33 speaker mic for 
THF6A


>
> Hello, all.
>
> I have a Kenwood SMC33 speaker mic for my THF6A, and have noticed recently
> that the little rotating clip on the back of the mic has gotten quite 
> loose,
> so that it almost spins freely.
>
> Is this normal for these mics, after extended use, and does anyone know of 
> a
> way I can tighten the clip back up again?
>
> Thanks, and 73 from Tom Behler:  KB8TYJ, Big Rapids, MI