thanks Vic.  I have read the manual and made sure that it is plugged into,
and set to the parallel port.  I'm at a loss.  

-----Original Message-----
From: Visually Impaired Computer Users' Group List
[mailto:[log in to unmask]] On Behalf Of Pereira Family
Sent: Monday, March 02, 2009 3:26 PM
To: [log in to unmask]
Subject: Re: [VICUG-L] Versapoint Printer again/still

Hi Albert:

I don't have any specific experience with that particular embosser, however
I will give you some generic things to check.

Make sure the embosser is expecting to receive data via a parallel port and
not a serial port.  Some models of embossers have both serial and parallel
ports.

The parallel port on your embosser will be a sentronicks  port, I have no
idea how to spell it correctly.  This will look different than your serial
DB9 or DB25 port in that there will be no screws just some protrusions that
allow a clip on each side to swing in and hold the connector in place.

Hope this helps as a beginning.

Vic

Pereira Family


    VICUG-L is the Visually Impaired Computer User Group List.
Archived on the World Wide Web at
    http://listserv.icors.org/archives/vicug-l.html
    Signoff: [log in to unmask]
    Subscribe: [log in to unmask]
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.0.237 / Virus Database: 270.11.5/1979 - Release Date: 03/01/09
17:46:00


    VICUG-L is the Visually Impaired Computer User Group List.
Archived on the World Wide Web at
    http://listserv.icors.org/archives/vicug-l.html
    Signoff: [log in to unmask]
    Subscribe: [log in to unmask]