You can get here through Windows, but since you are playing around with Echo
link, try this:
In Echo link Tools menu, go to "adjust volume". Now you're in a sub menu
with 2 choices : "playback" and "recording". Select "recording and that
will open up the windows recording volume control. Tab through a number of
settings until you get to "microphone volume" You can use your up and
down arrow keys to move that volume slider up and down. Try 50 percent for
starters. Tab one more time and you will land on the check box to enable
the microphone. If it says "unchecked" hit the spacebar to check it and
the mic that is connected to the soundcard will be active.
Hope this makes sense and is of some use to you.
73, Steve KW3A
----- Original Message -----
From: "fredjen1973" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, August 04, 2008 12:07 PM
Subject: Re: from Jennifer about interfaces
> Okay thanks I do not know how to get the place in windows to check some of
> that stuff. I followed the instruction of what the manual said about going
> to check a couple of boxes that werer checked in the volume or something
> likie that. But it did not bring up what it was supposed to.
> ----- Original Message -----
> From: "Steve Forst" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Monday, August 04, 2008 7:21 AM
> Subject: Re: from Jennifer about interfaces
>
>
>> Jennifer,
>>
>> If you have something other than the Signal Link USB, I have no info for
>> you. However if it is the Signal Link USB, the 3 front panel knobs from
>> left to right are:
>>
>> 1. TX
>> 2. RX
>> 3. delay
>>
>> The TX adjusts the transmit audio and the RX the received audio, as
>> though
>> you were in Windows audio control panel and moving the sliders up and
>> down.
>> The delay knob is like a vox and controls the time between tx and rx.
>>
>> Sorry I have little experience with Echo link and no experience using
>> Echo
>> Link with this interface. Perhaps you should check your windows audio
>> controls and be sure that the check box is selected to enable the mic
>> and
>> not the line inand that your mic gain in windows is set at some moderate
>> level for starters.
>>
>> Of course, the internal jumpers should have been installed correctly in
>> the
>> interface and the software drivers installed on your computer. Again,
>> if
>> you do not have the Signal Link USB, please disregard all of the above.
>> Whatever model you have, manuals and other tech info can be had at the
>> Tigertronics website:
>>
>> 73 and good luck, Steve KW3A
>>
>>
>>
>> ----- Original Message -----
>> From: "fredjen1973" <[log in to unmask]>
>> To: <[log in to unmask]>
>> Sent: Sunday, August 03, 2008 11:05 PM
>> Subject: from Jennifer about interfaces
>>
>>
>>> Hi does anyone have the single link inter face? If so can you tell me
>>> =
>>> what the
>>> knobs are? When I had someone help me hook it up I did not think to ask
>>> =
>>> them to
>>> tell me what the knobs are. Right now I can not get the echo link to =
>>> transmit so
>>> it will go to my radio. Also where can I go to adjust the mike settings
>>> =
>>> for echo
>>> link? I can hear on echo link but when I transmit witht he computer all
>>> =
>>> I hear is
>>> a carrier and not my voice when I turn the speaker all the way up.
>>>
>
|
