At 10:13 AM 10/26/2007, you wrote:
>Hi,
>To reset the TMV7A, press and hold down the memory key and turn on the
>radio.  The display asks for a OK from you.  you will now press the 4th
>button from the left main tuning knob on the bottom row. Then press the PTT
>switch on the microphone to make sure the process is clear. This will reset
>everything to the default settings.

Gary, This did not work for me, and the manual indicates to press memory 
again as the OK, but this doesn't seem to work either.



>Gary KB2YAA
>----- Original Message -----
>From: "Ted Filteau" <[log in to unmask]>
>To: <[log in to unmask]>
>Sent: Friday, October 26, 2007 9:33 AM
>Subject: Kenwood TM-V7A question
>
>
> > Hi to the list,
> >
> > As the subject indicates I have a TM-V7A question.  I've gotten my radio
> > into some weird state where it will not go into VFO mode or other modes
> > including crossband repeat.  But the main problem is I cannot reset the
> > radio to its defaults.  I probably hit some key combination inadvertently
> > to get the radio in this state, and now I can't get it out of it.  When I
> > hit the VFO button, the radio just gives me an error beep.  Also, the
> > voice
> > read out just gives the channel number with no frequency as it usually
> > does.
> >
> > Any suggestions appreciated.  I will call Kenwood tech support, but I
> > don't
> > expect much help when I say I can't read the display.  You know how that
> > goes.
> > Thanks!
> > Ted K1NGQ
> >
> >
> >
> > --
> > No virus found in this incoming message.
> > Checked by AVG Free Edition.
> > Version: 7.5.476 / Virus Database: 269.15.3/1081 - Release Date:
> > 10/19/2007 5:41 PM
> >
> >

Ted <[log in to unmask]>