Sender: |
|
Date: |
Tue, 18 May 2010 22:00:55 -0400 |
Reply-To: |
|
Message-ID: |
<ABB3DDF7CB994FF5B89A8464FB4B51C0@JoePC> |
Subject: |
|
MIME-Version: |
1.0 |
Content-Transfer-Encoding: |
7bit |
In-Reply-To: |
<606E8B15269C40A3A76C7EA53E4B99D8@alpha> |
Content-Type: |
text/plain; format=flowed; charset="iso-8859-1";
reply-type=response |
From: |
|
Parts/Attachments: |
|
|
Thanks John,
I already discarded it and replaced it with 2 Toshiba 640 G portable drives.
I got them at Costco for $69 each. I've copied my data to both of them and
only plan to connect them when I run SyncToy to backup my data.
I appreciate your help.
Joe
--------------------------------------------------
From: "John Sproule" <[log in to unmask]>
Sent: Tuesday, May 18, 2010 1:37 PM
To: <[log in to unmask]>
Subject: Re: [PCBUILD] Cyclical Redundancy Check Errors external hard drive
> Joe,
>
> I can't argue with your plan to just go ahead and replace the drive.
> However, if you have the time, you might try the write zeros to the drive
> utility and then re-run the diagnostic on it. It's possible that the
> problems are just at the file or configuration level and not the hardware
> itself. If it is a hardware problem, it may not even be able to overwrite
> the whole drive with zeros. Unfortunately, on a large USB drive, these
> tasks can take many hours. Maybe run it overnight.
>
> John
>
> ------Original Message Below-------
>
> Date: Sat, 15 May 2010 11:01:03 -0400
> From: Joe Trimarchi <[log in to unmask]>
> Subject: Re: Cyclical Redundancy Check Errors external hard drive
>
> Thanks John.
>
> The drive did come with WD Diagnostic software and I ran it. It reported
> too
> many bad sectors after running for about an hour so I guess I'll just be
> safe and replace the drive.
>
> Joe
>
> PCBUILD's List Owners:
> Bob Wright<[log in to unmask]>
> Mark Rode<[log in to unmask]>
PCBUILD's List Owners:
Bob Wright<[log in to unmask]>
Mark Rode<[log in to unmask]>
|
|
|