Hi.
A switch rated for VHF work would be less lossy, particularly since you are
only going to have modest levels of gain. If your coax runs are short and
not very lossy, you might be able to live with the losses in the switch,
and if it is a well made switch, they might not be that bad. On the other
hand, when I started out, I had a little two position antenna switch that
Radio Shack sold for CB and Ham applications that noticeably degraded the
antenna performance even at HF frequencies, so you never can tell. The
best way to tell is to measure your power output at the back of the radio,
and then measure it at the dipole end of the coax running through the
switch. You can tell whether the losses in your system are horrible in a
hurry that way. Bear in mind, that all feedlines and switches have some
loss, so expect the readings to be somewhat lower at the antenna. If they
are about 10% lower, it's probably pretty normal and liveable. If it's 50%
lower, you probably will want to try to figure out whether you are losing a
lot through the switch or if coax losses are eating up your power.
73,, de Lou K2LKK
At 04:01 PM 10/4/2007 -0400, you wrote:
>Hi list.
>I want to put up a 2 meter di-pole for my Kenwood TS-711A.
>I also want to be able to switch between my virtical and the di-pole,.
>I have an antenna switch from my children's band, uh, I mean my CB days, can
>I use this, or do I need a VHF switch if there is even such a thing?
>Thanks in advance for your help, and 73.
>
>
>
>--
>No virus found in this incoming message.
>Checked by AVG Free Edition.
>Version: 7.5.488 / Virus Database: 269.14.1/1050 - Release Date: 10/4/2007
>5:03 PM
Louis Kim Kline
A.R.S. K2LKK
Home e-mail: [log in to unmask]
Work e-mail: [log in to unmask]
Work Telephone: (585) 697-5740
|