It's possible. It should go back to it's original state when you change 
memory channels or hit the memory button, but if it was accidentally 
reprogrammed in all the button pushing, it could stay that way. I would say 
it's transmitting somewhere, unless something else is going on. If it has to 
do with the button pushing, it must be transmitting somewhere.
----- Original Message ----- 
From: "Jim Kutsch" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Thursday, August 09, 2007 7:20 AM
Subject: Re: TMG707A Stopped Transmitting


> Thanks to both of you for the recommendations.  I'll try them when I get
> home tonight.  Steve, the radio is not beeping when I press PTT so it
> doesn't seem to be in an error state.  John, could the crossband or offset
> have been changed even though I have the frequency and offset in a stored
> memory?  It was so hard to set those in the first place.  I agree, the
> software would be nice.
>
> again, thanks for the tips.
>
> 73,
> Jim, KY2D
>
>
> ----- Original Message ----- 
> From: "Steve Dresser" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Wednesday, August 08, 2007 9:56 PM
> Subject: Re: TMG707A Stopped Transmitting
>
>
> Good point, John.  I completely forgot about cross-band.  I'll bet that's
> the problem.  I've been bagged a few times by that one, and it can 
> certainly
> happen if you push buttons randomly.
>
> Steve
>
> ----- Original Message ----- 
> From: "John Miller" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Wednesday, August 08, 2007 20:38
> Subject: Re: TMG707A Stopped Transmitting
>
>
>> Is it possible the offsets were changed around? Or, maybe the cross band?
>> so
>> it's transmitting on another band, which can be changed by pushing the
>> function button, and the band button. Low beep is normal, high beep is tx
>> on
>> the other band from where you're listening. Off set is function then rev,
>> which is 2 over from the band button. Low beep is simplex, I forget the
>> order of the others but cycling through will likely get what you want.
>> Otherwise I wonder if there's something done in the menu.
>> ----- Original Message ----- 
>> From: "Jim Kutsch" <[log in to unmask]>
>> To: <[log in to unmask]>
>> Sent: Wednesday, August 08, 2007 8:20 PM
>> Subject: TMG707A Stopped Transmitting
>>
>>
>>> CQ TMG707A Experts,
>>> I'm reaching out to all of you Kenwood TMG707A operators for some quick 
>>> =
>>> help.  I've been digging through the manual but finding no answer.
>>>
>>> My fairly new Kenwood TMG707A stopped transmitting.  I'm using =
>>> preprogrammed channels that have worked fine for months.  When I push =
>>> the PTT, the fan starts, the receiver cuts out, but there's no output at
>>> =
>>> all.  I've verified nothing out by monitoring with another 2M rig. =20
>>>
>>> This problem started after several front panel buttons were pressed =
>>> randomly.  It's almost like a transmit lock was activated but if so, I'm
>>> =
>>> surprised that the fan still starts up.  I tried the directions for =
>>> keypad lock/unlock but no success.  Any ideas what happened and how to =
>>> recover?  I could do a reset to factory defaults but I hate to lose all 
>>> =
>>> of my frequency and PL programming.
>>>
>>> Thanks
>>> 73,
>>> Jim, KY2D
>>
>>
>>