Sender: |
|
Date: |
Tue, 4 Jan 2005 01:08:50 -0800 |
Reply-To: |
|
Content-type: |
text/plain; charset=US-ASCII |
Subject: |
|
MIME-Version: |
1.0 |
In-Reply-To: |
|
Content-transfer-encoding: |
7BIT |
From: |
|
Parts/Attachments: |
|
|
That's the jumper, and it's actually a small metal connector in a plastic
sheath. The most common ones have, I believe, a .1" pin spacing, and can be
found at almost any computer or electronics store in packages of 20 or 500.
You might even find them at Radio Shack.
The last time I needed to buy some, it was to configure some drives on
which the manufacturer had used a different *smaller* size. Not every place
had those, but a surplus/kit electronics store had them in similar quantity
for about $.12 each.
Dave Gillett
On 1 Jan 2005 at 15:55, Martha Conolley wrote:
> I have a tiny problem.
>
> I'm installing a new hard drive and I want to copy the old drive to the new one.
> This requires adjusting the jumper settings.
>
> You know that little piece of plastic you use to adjust jumper settings? I don't have one for the old drive--it did not require one to serve as a single drive. Does anyone know where I can get that little piece of plastic?
PCBUILD's List Owners:
Bob Wright<[log in to unmask]>
Drew Dunn<[log in to unmask]>
|
|
|