Matt,
You can also press Enter after each address, and Outlook Express will put in
the appropriate separator. If you go back and look at the field, you won't
see each address on its own line, but you can still enter them that way and
get away with it.
Steve
----- Original Message -----
From: "matt V" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Wednesday, November 29, 2006 22:46
Subject: Re: off topic maybe: Outlook Express question
> i only did the all headers once, now i get them on all new messages wich
is
> nice, and, not to argue, but to seperate addresses, you can use a comma
too
> i think
>
> ----- Original Message -----
> From: "Bob - KA5ETA" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Wednesday, November 29, 2006 8:27 PM
> Subject: Re: off topic maybe: Outlook Express question
>
>
> > Tom you have to create a new message. Then go to the view on the tool
bar
> > and click on all headers and then you will have the BCC field. All
you
> > have to do then is to put a semicolon between the names that you want
the
> > message to go to.
> > ----- Original Message -----
> > From: "T Behler" <[log in to unmask]>
> > To: <[log in to unmask]>
> > Sent: Wednesday, November 29, 2006 7:16 PM
> > Subject: off topic maybe: Outlook Express question
> >
> >
> > Hi, all.
> >
> > Does anyone know how to configure Outlook Express so that you can send
> > e-mail to either a list of blind carbon copy (BCC) addresses, or a list
of
> > "undisclosed recipients"?
> >
> > I have created a number of local ham radio mailing lists, and some folks
I
> > am sending e-mail to via these lists are worried that the list of
> > addresses
> > I use may be harvested and later used by spammers.
> >
> > I understand this concern, but don't quite know how to address it.
> >
> > 73 from Tom Behler: KB8TYJ
>
|