Sender: |
|
Date: |
Sat, 5 Sep 1998 22:40:55 -0700 |
Reply-To: |
|
Subject: |
|
MIME-Version: |
1.0 |
Content-Transfer-Encoding: |
7bit |
In-Reply-To: |
|
Content-Type: |
text/plain; charset="iso-8859-1" |
From: |
|
Parts/Attachments: |
|
|
The problem is that the Packard Bell instructions for the original CD-ROM
drive is still in your config.sys. If you would delete
DEVICEHIGH=C:\PBTOOLS\CR_ATAPI.SYS /E:MSCD0001 from your config.sys, you
should stop getting the message. (The message is telling you it can't find
the original CD-ROM drive. True, it can't. You removed it.)
Roxanne Pierce
R2 Systems, San Diego
mailto:[log in to unmask]
> -----Original Message-----
> From: John G. Cakars Sent: Saturday, September 05, 1998 21:47
>
> Packard Bell POS P75, Win95a, Wearnes 24x
>
> I just removed my 2x cd-rom and install a NewCom (aka Wearnes) 24x
> drive. When I start up the computer, it goes through it's paces and
> then I get a message "Interface board or cd-rom drive not ready. Insure
> that drive power is on and drive cables are correctly attached.
> (A)bort? or (R)etry?"
*****Config.sys*****
> DEVICE=C:\WINDOWS\HIMEM.SYS
> DOS=HIGH,UMB
> DEVICE=C:\WINDOWS\EMM386.EXE NOEMS I=B000-B7FF
> FILESHIGH=30
> BUFFERSHIGH=20
> STACKSHIGH=0,0
> FCBSHIGH=1
> DEVICEHIGH=C:\WINDOWS\MOUSE.SYS
> DEVICEHIGH=C:\PBTOOLS\CR_ATAPI.SYS /E:MSCD0001 (Delete this line)
-----
**Need help with PCBUILD mailing list? Send an Email to:**
Bob Wright<[log in to unmask]> or Drew Dunn<[log in to unmask]>
|
|
|