speaks for itself. a/b switches form VFO a to VFO b,  a=b makes vfo A equal 
B
----- Original Message ----- 
From: "Fred Olver" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Sunday, March 26, 2006 4:31 PM
Subject: Re: ts2000 question


Thanks, Steve, it was the gain control that was out of whack, but Steve,
what's the difference between the a/b button and the a=b button?

Fred Olver  [log in to unmask]
----- Original Message ----- 
From: "Steve Forst" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Sunday, March 26, 2006 3:04 PM
Subject: Re: ts2000 question


> Fred,
>
> Not sure  what  is going on at your end, but remember the 2000 has a main
> and a sub receiver and  on the main receiver has  two VFO's  A and B.
>
> To switch between a and b  vfo's, use a/b button.  To  change between main
> and sub rx, use the left and right  buttons of the  four buttons just to
> the right of the main tuning  knob.
>
> If the problem is on the sub rx, be sure it  is turned on by pushing in
> the
> sub volume control, which is the knob at the lower right hand corner of
> the
> front panel.
>
> If you can't rx on the main, be sure the  rf gain is fully clockwise.
> It
> is the outer ring of the knob just to the left of the  multi  function
> knob.
>
> To do a full reset:
> 1. Turn off rig.
> 2.
> Press and hold a/b button  while turning on  power
> 3  After rig comes on, release a/b button
> 4 Press a/b button  again and rig will reset.  If you don't push the a/b
> button  a second time within a few seconds, the reset will abort and not
> take place.  It is sort of giving you one last chance to change your mind
> before it's too late.
>
> Same instructions for a partial reset except use a=b button instead of a/b
> button.  Full reset  restores rig to the way it was  when you opened the
> box.   Partial reset leaves memories and menus intact.
>
> Good luck, Steve KW3A
>
> ----- Original Message ----- 
> From: "Fred Olver" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Sunday, March 26, 2006 8:32 AM
> Subject: ts2000 question
>
>
>> Morning guys,
>>
>> I find the a rcvr in my ts2k wants to rcv but does not, I tried toing a
>> partial and full reset but in reading the manual can't tell the
>> difference
>> in what is to be done, also, the radio is transmitting on the a rcvr, but
>> not rcving, this is true, at least on the two meter bands and 440
> megahertz
>> bands.  Also, think may have changed the rx so that the a rcvr is the b
>> rcvr, how to change back?
>>
>> Fred Olver  [log in to unmask]
>>
>>
>>