Subject: | |
From: | |
Reply To: | |
Date: | Sat, 12 Nov 2005 09:21:24 -0800 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
I like the Tnemec zinc primer. Used it about 12 years ago on some cast
iron in Tribeca as a primer. The finished job has held up good.
][<
Becker, Dan wrote:
>Word up on the query below? I'll forward replies.
>
>10-Q,
>
>
>
>>-----Original Message-----
>>From: [log in to unmask] [mailto:[log in to unmask]]
>>Sent: Tuesday, November 08, 2005 11:29 AM
>>To: [log in to unmask]
>>Cc: [log in to unmask]
>>Subject: [forum-l] Primer for Rusty Metal Surfaces
>>
>>
>>The Colorado city of Westminster owns the Savery Savory
>>Mushroom Farm Water Tower. The city desires to preserve the
>>tower as a visual landmark only. It is not intended to hold
>>water anymore. The water tank is rusted metal. The city
>>desires to bond the rust to the metal. To date, all sources
>>recommend hand-scraping loose paint and rust then power
>>washing the surface.
>>
>>After this is done, the city has been offered a choice
>>between either an epoxy primer (polymeric epoxy amine
>>primer/sealer made by Carboline) or a zinc-based primer made
>>by Tnemec. Can any one offer any advice regarding which type
>>of primer is preferable?
>>
>>Contact person with the City of Westminster is Vicky Bunsen,
>>(303) 430-2400 x 2111 or [log in to unmask]
>>
>>Thanks. I apologize for any cross-postings.
>>
>>
--
To terminate puerile preservation prattling among pals and the
uncoffee-ed, or to change your settings, go to:
<http://maelstrom.stjohns.edu/archives/bullamanka-pinheads.html>
|
|
|