Hi listers,
I recycle a lot of old PC stuff and cleaning is a part of almost every box I acquire. I have a small canister style vacuum and use it with the hose attached to the exhaust fitting and the crevice tool on the other end of the hose. I also find a 3" or 4" new clean paintbrush to be ideal for fans and heatsinks. The vacuum is a lot cheaper than the canned air. If it is not too obvious to say this, you should do this kind of work outdoors.
Regards,
Dale Mentzer
>Date: Sun, 19 Jun 2005 17:22:17 -0500
>From: Jerome Deyle <[log in to unmask]>
>Subject: Re: Proper Cleaning Inside the Tower
>
>Well, no guarantees, but what has worked for me is this:
>1. Power down, and unplug everything.
>2. open the case and use the vacuum nozzle to clean dirt off the metal
>surfaces (bottom of the case, air inlet holes/louvers, vent slots on power
>supply, etc). Use care not to touch any of the circuit board surfaces with
>the nozzle.
>3. Use compressed air (I use dry, filtered air from an air compressor and a
>small pencil nozzle) to blow dirt from all the nooks and crannies. Pay
>special attention to the processor heat sink and the power supply. I use a
>pencil to keep fans from spinning, so the air stream can reach the heat sink
>fins. Again, don't touch the board electronics, but keep the air nozzle back
>a bit. Also, don't forget the area around the drives. Modern hard drives run
>very warm, and fuzz and lint tend to block airflow around them.
>4. I always keep one hand on the steel part of the chassis to try to avoid
>static buildup.
>
>Thing to remember is that you're not looking for a white glove cleaning job.
>Just trying to encourage air flow and heat exchange so components don't
>overheat.
>
>I've found that many office computers are set on the floor beside the desk.
>By getting them up off the floor, even just setting them on a 6" high wooden
>box, the amount of dirt sucked into the machine is reduced considerably.
>
>I recommend to my service customers that business machines be cleaned 4
>times per year, home machines 2 times per year. More or less if the
>environment is exceptionally dirty or very clean, based on experience.
>
>>>>
>>>> I recently bought a Kensington Desktop Vacuum to use on my
>>>> desktop computing
>>>> equipment. The instructions that came with it only talk about proper
>>>> maintenance of the vacuum and not much about how I can safely
>>>> use it with my
>>>> computer equipment or WHICH equipment.
>>>>
>>>> I also bought a can of Memorex Air Duster and again, no
>>>> instructions on what
>>>> equipment I can safely clean with it or how.
>>>>
>>>> I look inside my computer and see that the insides really have
>>>> a buildup of
>>>> dust, but I don't want to do anything harmful. Any
>>>> direction on using
>>>> either of these two products would be greatly appreciated or
>>>> any tips of caution.
>>>> I've had computers for years, but have never attempted to
>>>> clean one, more
>>>> than just dusting with a soft cloth on the outside.
>>>>
>>>> Thank you in advance for any info that may be provided.
>>>>
>>>> Donna Parsons
>
>------------------------------
Do you want to signoff PCBUILD or just change to
Digest mode - visit our web site:
http://freepctech.com/pcbuild.shtml
|