Butch,

Write to me direct at [log in to unmask]

I can share what I know and put you in touch with a guy that gave me the
information.

Brian, k5in
----- Original Message -----
From: "Butch Bussen" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Friday, August 29, 2003 4:29 PM
Subject: Re: kenwood 2000.


> Do you have exact specifics, what pins go where?  And, where does the
> chip go, is this something that can be added to the 200, an interface
> box--I'm a ittle confused and more than a little dense.
> Thanks.
> Butch
>
>
> D On Fri, 29 Aug
> 2003, K5IN wrote:
>
> > Hi Butch,
> >
> > I have two rigs using the stone mountain qsy'er.  It needs an ic-chip to
> > invert the data.  The ic-chip is very readily found.  Then you need an
> > adapter or female plug to 9 pin serial plug.  Menu 56 on the ts2000
change
> > the baud rate to 4800 and away you go.  I know the qsy'er will work with
the
> > ts570 series radios and you would need the same adapter or 9 pin serial
plug
> > to access the radio.
> >
> > Brian, k5in
> > ----- Original Message -----
> > From: "Butch Bussen" <[log in to unmask]>
> > To: <[log in to unmask]>
> > Sent: Friday, August 29, 2003 8:56 AM
> > Subject: kenwood 2000.
> >
> >
> > > I am seriously considering the 2000.  I think the icom 745 pro is a
bit
> > > better on digital signal processing, but I think the better speech
access
> > > on the 2000 is worth the sacrafice.  What I really need to know is if
my
> > > stone mountain key pad I've used on all of my other kenwoods will plug
in
> > > and work on the 2000.  I think it is a 5 pin din, not sure.  I thought
I
> > > read somewhere it would but the rig needed something extra.  Any help
most
> > > appreciatecd.
> > > 73s
> > > Butch Bussen
> > > wa0vjr
> >