Just reading a BusLink manual - they recommend that you place the software
driver on the computer first through install/setup of the software.
Shutdown and then add the USB card. On the reboot - they say depending on
BIOS and system - Some Win98SE's will see the card and install the previous
installed software drivers OR that you should CANCEL the hardware detect and
then go through the software install a second time.
This is for a Buslink 5 port USB 2.0 card that I was getting the
information from.
Richard A. Freeman
>>> [log in to unmask] 02/21/2003 9:28:20 PM >>>
I ran into a problem on an older (P166) computer with Windows 98SE. The
Win98SE is a clean install with no application software yet installed.
When I add a USB card, the system detects the new hardware properly, but
when it tries to add the driver, I hangs. I tried several time to get it
installed, but no luck. The same card installed on a very similar P120
system with no such problems. I can't finish the boot when the board is
in place because Win98 insists on adding the drivers and we are back to
the lockup again. Should I assign specific IRQs to the PCI slot in BIOS?
There is a Diamond Stealth 64 PCI video, and an ISA Microsoft sound
board in it. Any suggestions?
Peter
-----------------------------------------------
The NoSpin Group
[log in to unmask]
The NOSPIN Group is now offering Free PC Tech
support at our newest website:
http://freepctech.com
The NOSPIN Group Promotions is now offering
Mandrake Linux or Red Hat Linux CD sets along
with the OpenOffice CD... at a great price!!!
http://freepctech.com/goodies/promotions.shtml