Mime-Version: |
1.0 |
Sender: |
|
Subject: |
|
From: |
|
Date: |
Sun, 2 Mar 2003 17:08:41 -0800 |
In-Reply-To: |
|
Content-Type: |
text/plain; charset="us-ascii"; format=flowed |
Reply-To: |
|
Parts/Attachments: |
|
|
This is a typical sort of failure caused by over clocking. You can boot DOS
but can't load windows. You can try upping the voltage a little bit, but
AMD K62 chips have never been known for being good for overclocking.
If you are doing audio editing, then you are using a office, Internet PC to
do it with. A K62 works great in the average office or home but it is not
meant to be used for anything like you are using it for. Overclocking a CPU
used for this purpose just makes things worse, because you can't fully
trust the encoding process.
These days high speed processors are so inexpensive that it really isn't
worth the trouble to try and squeeze a few megahertz out of a three year
old processor. If you need more processing power to do your editing, then
you really need a Pentium III, or better, system, to do the kind of work
you are attempting to do.
Rode
The NOSPIN Group
http://freepctech.com
At 07:44 PM 3/2/2003 -0500, you wrote:
>I own an AMDK6 2+/500 that I have stepped up to 550MHz using the clock
>multiplier jumpers on a BCM mobo. I can extract a little more speed out of
>the processor by using the 2.0/6.0 jumper setting, but when I do, Windows98SE
>fails to load properly. I get an error message right after the POST that a
>virtual device driver was either damaged or deleted. When I set the jumpers
>back to 5.5, Windows loads. Does Windows remember the hardware configuration
>and keep itself from loading if a major change is detected? I run a variety
>of music editing programs that are processor intensive and I have noticed an
>improvement in overall speed but would like to extract a little more without
>having to shell out big $ for a new mobo. Any suggestions?
>Chris Ryan
The NOSPIN Group provides a monthly newsletter with great
tips, information and ideas: NOSPIN-L, The NOSPIN Magazine
Visit our web site to signup: http://freepctech.com
|
|
|